2K EP Coating (-B- Component) - 1000kg IBC

Prepare substrate:

The substrate must be load-bearing, dry, sufficiently tensile and compressive strength, and clean. Dust, oil, grease and release agents must be removed in advance using suitable methods (preferred method: shot blasting; alternatively diamond grinding with thorough vacuuming).
Application should be carried out at 10-30 °C (room and substrate temperature) and a maximum relative humidity of 70 %.

Apply EP Coating in two layers:

1. EP Coating is applied in two layers. Approx. 350 g/m² should be planned per layer. Fresh material must be mixed for each layer. At 20 °C, the second layer may be applied no earlier than 16 hours and no later than 36 hours after application of the first layer.
   Important: If the second layer is not applied within 36 hours, the first cured layer must be sanded until it is completely matt (white haze) before the second layer can be applied.
2. For mixing, pour the complete contents of EP Coating component B into the container of EP Coating component A. Then add 2 × 100 g of EP Colour Paste and mix slowly and thoroughly with a drill for approx. 3 minutes at 300-400 rpm. 
   Working Time: approx. 30 minutes at 20 °C.
3. Immediately after mixing, pour the material onto the floor, spread it with a surface squeegee and then roll over it to achieve an even surface and retain the floor texture.
4. During curing, protect the area from moisture, dust and mechanical stress.
   Walkable after approx. 16 hours, fully load-bearing after approx. 7 days (temperature-dependent).

Colour deviations are possible due to raw material variations. When using different batches, base components should be pre-mixed. UV radiation and weathering may cause slight colour changes. To avoid curing and mixing problems, components A and B must first be thoroughly mixed, then transferred into a second clean container and mixed again.